Wireless Trigger (2 Outputs)


Remotely trigger up to two devices

Availability: Pre-Order Now


More Views

Product Description

The module has two relays (7 amps max per) on screw down terminal blocks. PicoBoos, BooBoxs, lights, or any other device that can be triggered from a relay can now be activated wirelessly. Use with any of our controllers and audio players or your own devices with trigger input.

Package Includes:

  • 1 x Control Switch Board with two 7-amp relays on it
  • 2 x Remote Controls with two buttons (red is relay 1, gray is relay 2)

Requires a 12VDC Power Supply. If you are powering from another device (such as a PicoBoo) then you will not require one.


Control Switch Board:

  • Operating Voltage: DC 12V
  • Max. Load: 7A Per Relay
  • Working Frequency: 315MHz / 433MHz
  • Encoding Type: Fixed Code
  • Output Mode: Two switch signal
  • Size: 50 x 70 x 18mm / 1.97 x 2.76 x 0.71 in
Remote Control:

  • Working Voltage: DC 12V (23A/12V battery)
  • Working Current: 10mA
  • Power: 10mW
  • Transmission Frequency: 315MHz / 433MHz
  • Oscillation Resistance: 4.7MΩ / 3.3MΩ
  • Transmission Distance: 650ft / 200m
  • Encoding Type: Fixed code

Please Note:

  • Actual antenna range will vary greatly depending on the installation and operating environment
  • All units use the same frequency and there is not a way to change that. What this means is that two units cannot be used in the same location and be triggered separately

Downloads and Documentation

Operating Manual  Download

Additional Information

Range 650 Feet
Output Capacity 7 Amps Each, 120VAC Max.
Output Type Relays
Supply Current 10 - 120mA
Supply Voltage 12 VDC

You may also be interested in the following product(s)

Dual Skull Kit

Dual Skull Kit

As low as: $799.99