Head Turn Character
As low as $589.99
In stock
- Head Turns Left and Right
- Mouth moves to Audio Signal
- LED Eyes move Left and Right
- Intelligent Random Movement
- Easy to setup, just add Audio
Usually ships in 1 week
Real-Time Mouth Control
The PicoTalk included inside the talking skull listens carefully to the audio and moves the servo in sync to make the character look like it’s doing the talking. No programming or specially encoded audio track required.
Moving LED Eyes
Does your current skull have staring problems? These skulls come with eyes that randomly look around, moving occasionally when the skull is quiet, and frequently when it's talking.
The LED eyes can be set to stay on, throb to the voice, or fade on when the character talks and out when it stops.
Head Turn
Like the moving eyes, the head will turn occasionally as the character talks. It's random, but it's smart about it, moving the eyes and head in the same direction so it looks natural.
The speed and amount of head-turn is completely adjustable.
Custom Skull Design
This is not a standard Bucky skull. Our skulls have been reworked to allow a clean installation of the internal hardware. And at almost one quarter the weight of the competition, these skulls are easier on the servos, and easier for you to install.
No Lonely Skeletons
Were you an only child? Did you grow up lonely and alone? Don't let your talking skull endure the same pain - buy two! You can craft a stereo audio track with one voice in each channel so they can chat, talk, or argue.
Easy Setup
Our talking skulls come completely ready to use. But if you'd like to change the amount of movement of the eyes, head, or sensitivity of the mouth, just lift the hood and turn the dial.
- Mouth servo open and closed limits
- Mouth servo speed
- Eye servo left and right limits
- Head turn servo left and right limits
- Head turn maximum speed
- Audio sensitivity
- LED Brightness and behavior
Mounting
The head-turn skull has a 3/8" shaft coupling about an inch below the skull's center plate. The coupling is designed to receive a 3/8" shaft of some kind, threaded or un-threaded. You must provide this rod. The coupling is secured to the rod by some set screws you can tighten with an Allen key.
Character Bodies
Custom bodies are available for some models. These must be purchased separately and can be seen here.
Includes
Our talking skulls ship with the following items:
- 1 x Talking Skull
- 1 x PicoTalk (installed and calibrated)
- 1 x 5V 2A Power Supply
- 1 x 3.5mm Audio Cable
- 1 x 3.5mm Y Cable