PicoBoo AC

$129.99
189 In stock
SKU
105

- Up to 2 minutes of sound
- Two AC socket outputs
- 10 watt Class D amplifier
- Triggerable

The PicoBoo AC is also available in a Starter Kit.
Not interested in doing any wiring, or just want to control AC devices? Then the PicoBoo AC is the controller for you.

Real-Time Programming

All programming of outputs and sounds are done in real-time using the programming buttons on the PicoBoo. Like all other Fright Ideas controllers, you can create an elaborate scene synchronized with sound by simply pushing some buttons.

Audio

The PicoBoo AC uses a built-in flash memory sound chip that makes it easy to playback and record up to 2 minutes of sound. Hook up any audio device to the PicoBoo’s audio-in and record the desired sound straight into the chip. No computers, no drivers, no converting sound formats. Note that the sound quality is similar to AM radio.

Up to 8 scare sounds can be recorded. The PicoBoo will automatically increment through them with each scare.

Amplifier

The PicoBoo AC now includes a 10 watt internal Class D amplifier. This allows the use of standard speakers which are smaller and easier to conceal than powered speakers - a big advantage when you need to hide the speaker in a prop.


AC Outputs

The picoBoo AC has two 10 amp relays brought out to two standard AC outlets. Want to leave a light turned on and then shut it off when the scare starts? No problem, each of the outputs can be set to either normally-on or normally-off.

Up to 2 minutes of animation at 30 frames per second can be recorded.


Trigger Input

The PicoBoo AC has a trigger input that can be used to trigger the scare automatically. This is most commonly used with PIR motion sensors, beam sensors, hand triggers, or pressure mats. If you want the PicoBoo to loop your scare indefinitely, connect the - and IN trigger pins with a small wire jumper.

Our selection of triggers can be seen here.


Ambient and Scare Modes

When the PicoBoo AC isn't busy scaring, it is by default in ambient mode. Program the PicoBoo’s sound chip with what you want the patrons to hear as they approach the scare, perhaps a little foreshadowing of the terror to come. Only audio can be programmed in Ambient mode.


Write-Protection

The PicoBoo AC has a write protection mechanism that helps prevent accidental or unwanted program changes.

Videos


PicoBoo AC Introduction

Downloads and Documentation

Documents

Quick Start Guide      Download
Operating Manual      Download
More Information
Amplifier 10 watt Class D
Audio Storage 2 Minutes
Audio Quality 8 bit Digital
Output Capacity 10 Amps Each, 10 Amps Total
Output Type AC Outlets (On/Off)
Outputs 2
Inputs 1
Supply Current 10A Max
Supply Voltage 120 VAC
We found other products you might like!
Copyright © 2001-present Fright Ideas. All rights reserved.